Turbocharger Lubrication - Lubricant Behavior and Factors That Cause Turbocharger Failure

This paper is a review of the turbocharger lubrication system and at the same time an attempt to point out and analyze the factors responsible for turbocharger wear, damage and failures. In particular, the conditions under which the lubricant works are presented, from its entrance up to its exit from the turbocharger bearing housing. Additionally, the consequences of failure to comply with the instructions for appropriate turbocharger operation are provided by the various manufacturers. Water cooled turbochargers (for which engine coolant is used), contribute significantly to the reduction of lubricant temperature, in the critical zones of its operation. This is achieved by reducing, the danger of the oil “coking” effect (charred oil residues) or its decomposition, because of high temperature occurring in these zones. Turbochargers shaft support development using semi-floating bush bearings has a significant impact on turbocharger manufacturing cost, as well as on their operational features. Further benefit may be had, when ball bearings are used (usually angular contact bearings are used) for turbocharger shaft support as they provide: a) a reduction of the kinetic friction coefficient, b) reduction of turbocharger lag during turbocharger shaft acceleration from low to high speeds, and c) reduced sealing problems. Regarding the failures that occur in turbochargers, their majority - up to 50% - is caused by problematic lubrication [1]. The rest of the failures are divided between causes related to human factors (such as misuse and inadequate maintenance of a turbocharged vehicle) and external factors such as foreign objects entering either the compressor or turbine housings

Nontrivial dependence of dielectric stiffness and SHG on dc bias in relaxors and dipole glasses

Dielectric permittivity and Second Harmonic Generation (SHG) studies in the field-cooled mode show a linear dependence of dielectric stiffness (inverse dielectric permittivity) on dc bias in PMN-PT crystals and SHG intensity in KTaO$_{3}$:Li at small Li concentrations. We explain this unusual result in the framework of a theory of transverse, hydrodynamic-type, instability of local polarization.Comment: 5 figure

Dielectric Properties Of Lead Potassium Lithium Niobate (Pb1,85K1,15Li0,15Nb5O15) With Tetragonal Tungsten Bronze (TTB) Type Structure

A new tungsten bronze ceramic oxide, Pb2-xK1+xLixNb5O15 (PKLN) (x =0.15) was prepared by high temperature solid-state reaction route. Structural and electrical properties are investigated using X-ray diffraction and dielectric measurements. Room temperature XRD pattern confirms the formation of the compound with an orthorhombic crystal system. The dielectric permittivity and the loss tangent of the sample have been measured in a frequency range 1Hz–1MHz and a temperature range 35–550 °C. Studies of dielectric properties show that the compound exhibits an anomaly at 425°C (usually called transition temperature).The electrical parameters of the material were studied using complex impedance spectroscopy showing that the compound exhibits non-Debye of relaxation process. In the paraelectric phase, activation energy was determined and the value is Eτ = 0.68 eV. The present ceramic is promising candidate for high dielectric constant and low loss dielectric ceramic.A new tungsten bronze ceramic oxide, Pb2-xK1+xLixNb5O15 (PKLN) (x =0.15) was prepared by high temperature solid-state reaction route. Structural and electrical properties are investigated using X-ray diffraction and dielectric measurements. Room temperature XRD pattern confirms the formation of the compound with an orthorhombic crystal system. The dielectric permittivity and the loss tangent of the sample have been measured in a frequency range 1Hz–1MHz and a temperature range 35–550 °C. Studies of dielectric properties show that the compound exhibits an anomaly at 425°C (usually called transition temperature).The electrical parameters of the material were studied using complex impedance spectroscopy showing that the compound exhibits non-Debye of relaxation process. In the paraelectric phase, activation energy was determined and the value is Eτ = 0.68 eV. The present ceramic is promising candidate for high dielectric constant and low loss dielectric ceramic

Laser induced ultrafast combustion synthesis of solution-based AlOx for thin film transistors

Solution processing of amorphous metal oxides using excimer laser annealing (ELA) has been lately used as a viable option to implement large-area electronics, offering high quality materials at a reduced associated cost and process time. However, the research has been focused on semiconductor and transparent conductive oxide layers rather than on the insulator layer. In this work we present amorphous aluminum oxide (AlOx) thin films produced at low temperature (≤150 °C) via combustion synthesis triggered by ELA, for oxide thin film transistors (TFTs) suitable for manufacturing flexible electronics. The study showed that combining ELA and combustion synthesis leads to an improvement in the dielectric thin film's densification in a shorter time (≤15 min). Optimized dielectric layers were obtained combining a short drying cycle at 150 °C followed by ELA treatment. High breakdown voltage (4 MV cm−1) and optimal dielectric constant (9) was attained. In general, TFT devices comprising the AlOx fabricated with a drying cycle of 15 min followed by ELA presented great TFT properties, a high saturation mobility (20.4 ± 0.9 cm2 V−1 s−1), a small subthreshold slope (0.10 ± 0.01 V dec−1) and a turn-on voltage ∼0 V. ELA is shown to provide excellent quality solution-based high-κ AlOx dielectric, that surpass other methods, like hot plate annealing and deep ultraviolet (DUV) curing. The results achieved are promising and expected to be of high value to the printed electronic industry due to the ultra-fast film densification and the surface/area selective nature of ELA

The basic approval voting game

We survey results about Approval Voting obtained within the standard framework of game theory. Restricting the set of strategies to undominated and sincere ballots does not help to predict Approval Voting outcomes, which is also the case under strategic equilibrium concepts such as Nash equilibrium and its usual refinements. Strong Nash equilibrium in general does not exist but predicts the election of a Condorcet winner when one exists

Maximum Rank Query

http://www.vldb.org/pvldb/vol8/p1554-Mouratidis.pdf</p

Vaccinia Virus G8R Protein: A Structural Ortholog of Proliferating Cell Nuclear Antigen (PCNA)

BACKGROUND: Eukaryotic DNA replication involves the synthesis of both a DNA leading and lagging strand, the latter requiring several additional proteins including flap endonuclease (FEN-1) and proliferating cell nuclear antigen (PCNA) in order to remove RNA primers used in the synthesis of Okazaki fragments. Poxviruses are complex viruses (dsDNA genomes) that infect eukaryotes, but surprisingly little is known about the process of DNA replication. Given our previous results that the vaccinia virus (VACV) G5R protein may be structurally similar to a FEN-1-like protein and a recent finding that poxviruses encode a primase function, we undertook a series of in silico analyses to identify whether VACV also encodes a PCNA-like protein. RESULTS: An InterProScan of all VACV proteins using the JIPS software package was used to identify any PCNA-like proteins. The VACV G8R protein was identified as the only vaccinia protein that contained a PCNA-like sliding clamp motif. The VACV G8R protein plays a role in poxvirus late transcription and is known to interact with several other poxvirus proteins including itself. The secondary and tertiary structure of the VACV G8R protein was predicted and compared to the secondary and tertiary structure of both human and yeast PCNA proteins, and a high degree of similarity between all three proteins was noted. CONCLUSIONS: The structure of the VACV G8R protein is predicted to closely resemble the eukaryotic PCNA protein; it possesses several other features including a conserved ubiquitylation and SUMOylation site that suggest that, like its counterpart in T4 bacteriophage (gp45), it may function as a sliding clamp ushering transcription factors to RNA polymerase during late transcription

Rapid Internalization of the Oncogenic K+ Channel KV10.1

KV10.1 is a mammalian brain voltage-gated potassium channel whose ectopic expression outside of the brain has been proven relevant for tumor biology. Promotion of cancer cell proliferation by KV10.1 depends largely on ion flow, but some oncogenic properties remain in the absence of ion permeation. Additionally, KV10.1 surface populations are small compared to large intracellular pools. Control of protein turnover within cells is key to both cellular plasticity and homeostasis, and therefore we set out to analyze how endocytic trafficking participates in controlling KV10.1 intracellular distribution and life cycle. To follow plasma membrane KV10.1 selectively, we generated a modified channel of displaying an extracellular affinity tag for surface labeling by α-bungarotoxin. This modification only minimally affected KV10.1 electrophysiological properties. Using a combination of microscopy and biochemistry techniques, we show that KV10.1 is constitutively internalized involving at least two distinct pathways of endocytosis and mainly sorted to lysosomes. This occurs at a relatively fast rate. Simultaneously, recycling seems to contribute to maintain basal KV10.1 surface levels. Brief KV10.1 surface half-life and rapid lysosomal targeting is a relevant factor to be taken into account for potential drug delivery and targeting strategies directed against KV10.1 on tumor cells